JoBear2
Registered: February 2009
Location: NE of Melbourne, Victoria
Posts: 108
|
This is the inside of my Gift Card Holder. I have attached self-adhesive velcro dots so that the contents of the holder are secure when closed. These velcro dots are readily available from supermarkets and craft stores. I cut mine in half so that they fitted!! The little red square of cs at the top is to hide the ribbon end which I should have tied around the front panel before I attached it to the front - something I will do next time.
Note that the back of the card holder was embossed with my Cuttlebug using the Swiss dots embossing folder and then I just used my Fiskars Threading Water punch to punch the end that folds over and secured the far LHS & RHS with double-sided tape but left the section where the Card tucks in (hope that makes sense!).
See my other photo for the front view.
|
